九一茶馆_全国龙凤茶楼论坛_南宁夜生活桑拿论坛交流中心

PA 2 into 6 out of the digital audio processor function characteristics:

In a stereo system, peripheral equipment supplement and sideline is complex, and equipment, including to make sound become strong compressors, enhance the effect of exciter, decorate quality equalizer, filtering or improve some signal with the parameters of the equalizer, eliminate whistlers feedback suppressor, protect sperker limiter, calibration horn time delay timer, to compensate the frequency response room defects of equalizer......So much of the equipment, make engineering are dizziness, besides the general users.See much less experienced users, such as the stars in the sky of the display lamp, dotted with control keys, inextricably cables, really do not know how to start, daunting.
DriveRackTMPA design engineers to understand the needs of users, the design of a new generation of peripheral devices, the combination of all of the above functions.From now on, from the mixer to pa just one device, an all-encompassing surrounding the basic function of the controller.Not only so,DriveRackTMPA design also look after the convenience of engineering contractor, built into the most JBL speakers and Crowm technical parameters of the power amplifier.Project traders need to progress through the Setup Wizard (set navigation elf) guidance, to choose the order and the input device model, working state and the rest of the cumbersome fine-tuning work finished by DriveRackTMPA automatically.
In RTA -m standard test microphone and open the function of Auto - automatic balanced EQ, DriveRackTMPA can automatically adjusting the balance of the room, the compensation part caused by poor building acoustic frequency response of the defects.Fast track feedback suppressor and precise output limiting protection, is a boon users and engineering business, make sure the system work stable.

1.stereo feedback suppressor 2 x 12 groups of fast track notch filter
2.double 28 graphic equalizer
3. classic DBX compressors
4. 120 a subharmonic synthesizer
5. 2 * 3, 2, 2 * 4 * 5, 2 x 6 points frequency combination selection

6. stereo parameters equalizer
7. stereo output limiting device
8. speakers fine-tuning latency

9. pink noise generator

10. Auto - automatic room EQ balanced compensation
11. setting JBL speakers and Crown amplifier Setup Wizard (set navigation elf) function
12. 25/25 users to set factory preset program memory
13. input of two groups, 6 set of output
14. RTA -m real-time spectrum analysis meeting microphone input in panel, with a phantom power supply
15. 24 - Bit A/D converter to provide greater than 110 db dynamic range
16 DBX patent Type IVTMA/D conversion circuit
17. graphic LCD display

Technical parameters:
Analog input: input the number: (1) the RTA microphone input
(2) the line input
Category: electronic balance/RF filter, female XLR
Impedance: > 40 k Ω
Input level: is a + 20
Common mode rejection ratio: > 45 db
RTA microphone phantom power supply: + 15 VDC
RTA microphone equivalent input noise: < - 110 is a 22 hz, - 22 KHZ, 150 Ω
Analog output:
Output number: (6) lines output
Category: electronic balance/RF filter, XLR
120 Ω impedance:
Output level: is a + 20
A/D features:
Category: DBX Type IV conversion
Dynamic range: 110 db right of A meter, 107 db shall not be entitled to gauge
Type IV dynamic range: 123 db, including transient signal, A weighting, 22 KHZ BW
121 db, including transient signal, no weight, 22 KHZ BW
115 db, including signal, A weighting, 22 KHZ BW
Sampling frequency: 48 KHZ

A/D features:
Dynamic range: 112 db right of A meter, 110 db shall not be entitled to gauge
System features:
Dynamic range: > 110 db shall not be entitled to meter, > 107 db right of A meter
Noise: THD + 0.002%, + 4 is a, 1 KHZ, 0 db input gain
Frequency response: 20 hz - 20 KHZ, plus or minus 0.5 dB
Channel crosstalk: < - 110 db and 120 db
Input to output crosstalk: < - 110 db
Delay: each output channel 10 ms (a total of 60 ms)